锐捷无线AP与无线控制器二层注册上线与状态查看

一 设备配置1.AC基本配置与AP上线配置hostname test-AC!wlan-config 1 guest //配置无线wlan-idssid-code utf-8tunnel local!ap-group defaultinterface-mapping 1 101 ap-wlan-id 1 //默认AP组下映射用户vlan101和前面的无线wlan-id 1用户vlan dhcp在核心交换机!wlansec 1 //配置wlan-id加密类型和密码security rsn enablesecurity rsn ciphers aes enablesecurity rsn akm psk enablesecurity rsn akm psk set-key ascii 88888888security wpa enablesecurity wpa ciphers aes enablesecurity wpa akm psk enablesecurity wpa akm psk set-key ascii 88888888!ac-controller //无线控制器用户限速与版本升级wqos fs enablenetuser B0E5.EDE4.6EDC inbound average-data-rate 100 burst-data-rate 100netuser B0E5.EDE4.6EDC outbound average-data-rate 100 burst-data-rate 100netuser DC31.D1E8.E75F inbound average-data-rate 10 burst-data-rate 10netuser DC31.D1E8.E75F outbound average-data-rate 10 burst-data-rate 10netuser B0EB.575D.0A6B inbound average-data-rate 8 burst-data-rate 8netuser B0EB.575D.0A6B outbound average-data-rate 8 burst-data-rate 8active-bin-file AP_RGOS11.9(6)W1B1_S2X2-19_09192519_install.binactive-bin-file AP_RGOS11.1(5)B81P14_S2C3-01_06140109_install.binactive-bin-file AP_RGOS11.1(9)B1P30_S1C2-21_08190210_install.binactive-bin-file AP_RGOS11.9(6)W1B1_S2X2-06_09192519_install.binactive-bin-file AP_RGOS11.1(5)B9P28_S1C3-01_07151619_install.binap-image auto-upgradeno ac-control disablecountry CN802.11g network rate 1 disabled802.11g network rate 2 disabled802.11g network rate 5 disabled802.11g network rate 6 supported802.11g network rate 9 supported802.11g network rate 11 mandatory802.11g network rate 12 supported802.11g network rate 18 supported802.11g network rate 24 supported802.11g network rate 36 supported802.11g network rate 48 supported802.11g network rate 54 supported802.11b network rate 1 disabled802.11b network rate 2 disabled802.11b network rate 5 disabled802.11b network rate 11 mandatory802.11a network rate 6 mandatory802.11a network rate 9 supported802.11a network rate 12 mandatory802.11a network rate 18 supported802.11a network rate 24 mandatory802.11a network rate 36 supported802.11a network rate 48 supported802.11a network rate 54 supported!service dhcp //AC作为AP DHCP地址池通过option138属性注册上线!ip dhcp pool ap_guanlioption 138 ip 1.1.1.1network 192.168.101.0 255.255.255.0default-router 192.168.101.254!interface Loopback 0ip address 1.1.1.1 255.255.255.0!interface VLAN 3000ip address 192.168.101.254 255.255.255.0!vlan range 1,10,101,3000!interface GigabitEthernet 0/2switchport mode trunk!ip name-server 114.114.114.114 //无线控制器与公有云WIS服务器对接配置!cloud-diagnosis enable synccloud-diagnosis enablecloud-diagnosis server http://wis.ruijie.com.cn:52002/macclog/upload/conf/synccloud-diagnosis sync-server http://wis.ruijie.com.cn:52002/macclog/sync!2.创建AP组并将AP添加到AP组下test-AC(config)# ap-group test-grouptest-AC(config-ap-group)#exittest-AC(config-ap-group)#test-AC(config)# ap-config AP0001test-AC(config-ap)# ap-group test-group二 状态查看1.AP地址查看与上线查看test-AC#show ap-config summary show ap status Radio: Radio ID or Band: 2.4G 1#, 5G 2#E enabled, D disabled, N Not exist, V Virtual APCurrent Sta numberChannel: * GlobalPower Level PercentOnline AP number: 141Offline AP number: 3AP Name IP Address Mac Address Radio Radio Up/Off time State---------------------------------------- --------------- -------------- ------------------- ------------------- ------------- -----101 192.168.101.105 5869.6c5b.09fa 1 E 0 1* 100 2 E 0 153* 100 25:03:18:58 Run102 192.168.101.104 5869.6c5b.09f0 1 E 0 11* 100 2 E 0 149* 100 22:19:22:57 Run103 192.168.101.107 5869.6c5b.0a3b 1 E 0 6* 100 2 E 1 165* 100 22:19:42:23 Run104 192.168.101.102 5869.6c5b.0a6d 1 E 0 11* 100 2 E 0 149* 100 25:03:29:54 Run105 192.168.101.106 5869.6c5b.09f5 1 E 0 6* 100 2 E 1 165* 100 25:03:54:54 Run107 192.168.101.13 1082.3db1.2d09 1 E 0 1 100 2 E 1 149* 100 23:03:09:00 Run2.无线用户查看test-AC#show ac-config client show sta status AP : ap name/radio idStatus: Speed/Power Save/Work Mode/Roaming State/MU MIMO, E enable power save, D disable power saveBACKUP STA is on peer ACTotal Sta Num : 196Backup Sta Num : 0STA MAC IP Address AP Wlan Vlan Status Asso Auth Net Auth Up time-------------- ------------------------------ ---------------------------------------- ---- ---- ------------------ --------------- --------------- ------------008a.5510.0c53 10.0.1.78 112/3 1 101 270.0M/D/ac WPA2_PSK OPEN 0:00:31:3004c1.d882.42eb 10.0.0.120 318/2 1 101 156.0M/D/ac/mu WPA2_PSK OPEN 0:00:25:5904f1.691d.47ff 10.0.0.241 406/2 1 101 173.5M/E/ac WPA2_PSK OPEN 0:00:25:130c6a.c49f.8f9f 10.0.1.64 103/2 1 101 130.0M/E/ac WPA2_PSK OPEN 0:00:40:370cb9.833c.5f7e 10.0.0.94 2F3 1 101 432.5M/E/ax WPA2_PSK OPEN 0:00:11:403.隧道状态查看test-AC#show capwap stateCAPWAP tunnel state, 141 peers, 141 is run:Index Peer IP Port State Mac Address1 192.168.101.3 10000 Run 1082.3db1.3c812 192.168.101.63 10000 Run 1082.3daf.62383 192.168.101.38 10000 Run 5869.6c5b.0b714 192.168.101.124 10000 Run d431.2773.27ba8 192.168.101.82 10000 Run 0074.9cdd.84964.AP硬件版本查看YFDZXXXFX-AC#show ap-device informationAP(111)s device information:CPU type : MIPS 74Kc V5.0, 386MHzMemory type : Hynix DDR2(16bit)Flash size : 31MBMac Address : 0074.9cdd.5c72AP(1)s device information:CPU type : MIPS 74Kc V5.0, 386MHzMemory type : Hynix DDR2(16bit)Flash size : 31MBMac Address : 0074.9cdd.61ceAP(3)s device information:CPU type : MIPS 74Kc V5.0, 386MHzMemory type : Hynix DDR2(16bit)Flash size : 31MBMac Address : 0074.9cdd.627e5.AP是否本地转发认证查看1登陆到AP查看射频卡配置show run interface dot11radio 1/0.1显示为mac-mode local为本地转发。2登录AP通过命令debug fwd dump-mode显示为wlan 1 tunnel local为本地转发6.命令查看汇总show runshow ap-config summaryshow ac-config clientshow ac-configshow capwap stateshow ap-device informationshow ip in bshow ll nshow versionshow ac-config serial-product